Charnwood W616 Instrucciones de operaciones

1 10” TABLE SAW OPERATING INSTRUCTIONS MODEL: W616 Charnwood, Cedar Court, Walker Road, Hilltop Industrial Estate, Bardon, Leicestershir

10 Cutting Width The rip fence is used to make longitudinal (with the grain) cuts. The fence can be fitted on either side of the saw blade. Set the f

11 Blade Removal and Replacement Always switch off and unplug the saw before removing or replacing the blade. A section of the table, to the righ

12 Routine Maintenance After every 20 hours of running, it is necessary to check the carbon brushes in the motor for wear. The carbon brushes must

13 Troubleshooting Saw vibrates Check all nuts and bolts for tightness, check tilt is locked and check that blade is not damaged. Cuts are slow, wo

14 EXPLODED DIAGRAM

15 Parts List Item Part QTY Item Part QTY 01 Blade retaining nut 1 51 Side panel, right 1 02 Washer 1 52 Push stick retainer, front 1 03 Saw blade 1

16 Charnwood, Cedar Court, Walker Road, Hilltop Industrial Estate, Bardon, Leicestershire, LE67 1TU Tel.

2 GENERAL SAFETY RULES WARNING: Do not attempt to operate the machine until you have read thoroughly and understood completely all instructions, ru

3 12. Wear proper apparel. Avoid loose clothing, gloves, ties, rings, bracelets, and jewellery which could get caught in moving parts. Non-slip foo

4 7. Do not cut material that is badly warped or which has screws or nails in it 8. Be extra vigilant when cutting stock which has loose knots in

5 Unpacking Open the carton and carefully unpack all of the contents. Familiarise yourself with the parts and take the time t

6 Do the same with the rails marked ‘A’, fitting these to the sides. Bolt on the four legs, ensuring that they fit outside the rails and that t

7 The side extensions are locked in place with the four large, black knobs which screw into the underside of the main table. Bolt the two

8 Remove the bolt and wing nut from the crown guard and fit the guard over the top of the riving knife. Replace the bolt and wing nut. Tighten

9 Fit the other end of the extractor hose to the side of the T connector at the back of the machine, as shown. The diameter of the extraction out